Resized in Bambu to 200 by 200  only move x and y Do Not alter Z as will not print correct
if you do. Still learning hueforge so first attempt at colour pop
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
    PLA+ JAYO Black Transmission Distance: 0.3
    PLA+ JAYO Gray Transmission Distance: 2.5
    PLA+ JAYO White Transmission Distance: 6
    PLA+ JAYO Red Transmission Distance: 4
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #6 (0.56mm) swap to Gray
    At layer #10 (0.88mm) swap to White
    At layer #18 (1.52mm) swap to Red for the rest.