CR2032 Box for 5 Cells – Print-in-Place
Remixed by
Copyright Claim
CR2032 Box for 5 Cells – Print-in-Place
Remixed by
Boost
140
264
68
Print Profile(3)
2 COLORS, 0.16mm layer, Arachne, 3 walls
Designer
47 min
1 plate
single color, 0.16mm layer, Arachne, 3 walls
Designer
31 min
1 plate
0.2mm layer, 2 walls, 15% infill
24 min
1 plate
Boost
140
264
68
0
351
284
Released
Description
Pre-colored .3mf file included.
Best to be printed in wall generator Arachne and 3 walls.
It's a bit hard to close and open the box for the first time. You need much power, but after that it will work much easier.
I could have used bigger tolerance but then the box would work only shortly.
Also available for CR2450 cells.
Comment & Rating (68)
All
Print Profile
2 COLORS, 0.16mm layer, Arachne, 3 walls
Box schließt leider nicht ganz
The designer has replied
1
Reply
Beim ersten Schließen braucht man recht viel Druck. Danach geht es einfacher.
0
Reply
Print Profile
2 COLORS, 0.16mm layer, Arachne, 3 walls
batteries fit well, printed effortlessly, perfect 👌
0
Reply
Print Profile
2 COLORS, 0.16mm layer, Arachne, 3 walls
initial layer was oddly slow but otherwise solid print, has a great hinge and not rough
0
Reply
Print Profile
single color, 0.16mm layer, Arachne, 3 walls
good job
0
Reply
print in Tinmorry PETG-ECO, only issue is difficult to open it
0
Reply
Print Profile
2 COLORS, 0.16mm layer, Arachne, 3 walls
Prints great, just need more batteries to fill it up!
0
Reply
Print Profile
2 COLORS, 0.16mm layer, Arachne, 3 walls
Nice design but difficult to open and close. I had cut the flange.
0
Reply
Printed in PETG
0
Reply
Print Profile
2 COLORS, 0.16mm layer, Arachne, 3 walls
Everything is great 👍
(Edited)
0
Reply
Print Profile
2 COLORS, 0.16mm layer, Arachne, 3 walls
Very usefull, thank you.
0
Reply
Related Models
© 2024 MakerWorld