Description
I wanted a protective cap for my 4-wire trailer plug.
The plug i have is round and pin are somewhat protected so all other design wouldn’t fit.
So i made one from scratch using Onshape.
This fit snug on the plug using TPU but there seams to be plenty of different model so check for measurement first.
Printing
Filament: Sunlu TPU 95A
Nozzle: 0.4mm
Layer Height: 0.2mm
Walls: 2
Infill: Grid
Infill : 15%
Brims: Disabled
Textured PEI plate
Installing:
Use the hole at the end to slide the plug through so you don’t loose the cap.
* You can add some "Dielectric grease" inside to keep the contact all clean and lubricated. *