Simple Couch Riser - Couch Erhöhung

As our iRobot vacuum robot couldn't get under the couch due to a lack of height, I created a small riser.

The existing feet have a diameter of 79mm and a height of 45mm. The elevation raises the couch by an additional 50mm and the retained original leg is positioned in the hollow part of the elevation.

I made the outer wall slightly wider so that the infill is printed completely through the outer wall of the hollow section, as the hollow section was torn off at the transition in the first prototype.

The absolute dimensions of the raised section:
- Total height: 95mm
- Solid part: 50mm height
- Hollow part: 45mm height
- Inner diameter of hollow part: 80mm
- Total outer diameter: 90mm

I had to print 10 feet - I mainly used PETG and PLA+ in the non-visible area ;-)

Maybe someone can use the riser as well...