A1 heatbed replacement LEVEL test after tramming

Copyright Claim

A1 heatbed replacement LEVEL test after tramming

Boost
1
3
1

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
Designer
43 min
1 plate
5.0(1)

Boost
1
3
1
1
8
10
Released

Description

ESSENTIAL TO PERFORM AFTER A1 HEATBED REPLACEMENT

 

After you replace your A1 heatbed, you must tram it to make the bed level. This print will test if the bed has been trammed properly. If you have installed and trammed the new heatbed properly, this test will produce a thin two layer sheet. It should be perfectly flat like a piece of paper. If there are any high or low spots, this indicates that the bed has not been properly trammed.

 

You can also use this print to clean your A1 bed before printing with light colors to ensure the bed is clean of darker residue. It is also essential to print this before you attempt any hueforge or light box print to ensure yout bed is perfectly clean.

 

Note: Be sure to run a full bed level when you print this model for best results.

Comment & Rating (1)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 2 walls, 15% infill
perfect just what I need to make sure my bed replacement didn't need to be trimmed.
0
Reply
No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.