ESUN PLA AMS spool cardboard adapter
Copyright Claim
ESUN PLA AMS spool cardboard adapter
Boost
9
17
6
Print Profile(1)
0.2mm layer, 5 walls, 15% infill
Designer
21 min
1 plate
Boost
9
17
6
0
32
32
Released
Description
Ciao,
I created this Esun cardboard spool adapter for PLA filament spools. With these adapters you can use cardboard spools in the AMS without causing winding problems or excessive dirt/dust. The adapter has a very thin outer edge (0.4 mm.) and does not cause rubbing problems with the AMS cover. I recommend printing them in PETG so you can put the coils in the dryers and not have deformation problems.
Comment & Rating (6)
All
Print Profile
0.2mm layer, 5 walls, 15% infill
had to alter the sizes to get them to fit some spools, not the designers fault at all. measured 30+ esun spools and they have a variation of +-5mms.
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 5 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld