👍👍Please 🚀Boost this model if you like it, it really helps!👍👍

Uses no extra screws/parts, and resizable dowels for maximum strength, and adjustability!

I wanted a basic, almost universal handgun holder that was adjustable to each handgun. I also wanted to not have a requirement for any screws or hardware.

You can use different length dowels in each rack to customize each slot, so a subcompact can sit right next to a full size if needed!

Notes for Printing and assembly:

Only 2 steps - So take your Time!

1.) Dowel is friction fit after cleanup on most printers, so use a deburring tool(cleanest results) and/or sand paper to clean brim/any elephants foot off, and make sure the holes are clear. Protip: ½ a second with blue part of the flame of a lighter can clean up some of the plastic “Whitening”

2.)Carefully\Slowly press in dowel while carefully supporting each slat that you go through, and take your time. Keep an eye out on each slat, while installing, so that no slat gets too bent.

Note: Don't force it excessively, if you have press too hard that your starting to struggle, you may get it stuck, pull it out slowly and trim or sand it a bit more as needed, and try again. If you accidentally trim too much that's okay, you can just use Super glue or 3d print glue.

A1 Mini Users only - 4 Slot will print on a A1 mini, but since there is very little room for a brim, make sure you have got your bed adhesion on point, you are using know good quality filament, and there is no drafts that can warp edges and pull up the build-plate or model.

Always store any firearm, or anything that looks like a firearm away from untrained people/children without responsible supervision.