chest

Remixed by

chest

Remixed by
Boost
257
486
101

Print Profile(2)

All
X1 Carbon
P1S
P1P
X1
X1E
A1
A1 mini

0.08mm layer, 2 walls, 15% infill
0.08mm layer, 2 walls, 15% infill
Designer
9.4 h
2 plates
4.8(57)

0.08mm layer, 2 walls, 15% infill
0.08mm layer, 2 walls, 15% infill
13.3 h
4 plates
4.5(10)

Open in Bambu Studio
Boost
257
486
101
87
919
412
Released

Description

Boost Me (for free)

please consider Boosting me if you like the model and you want to support me so I can make more.
thank you!

I found this chest in the style of a Fortnite loot chest on Printables but it didn't have any pins for its hinges, so I added a couple to the model.

very fun to put together after all the parts are printed!

I've already set all the best parameters to print it correctly in the .3mf file

Comment & Rating (101)

Please fill in your opinion
(0/5000)

Print Profile
0.08mm layer, 2 walls, 15% infill
Printer well, used super glue to assemble. next time in would glue with the lid closed position with bolts set through as I didn't quite align them. no fault of the profile.
The designer has replied
1
Reply
thank you for your feedback!
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
son uses this to hold his money and loves it
The designer has replied
1
Reply
I'm so glad he likes it and he found a good use for it!
(Edited)
1
Reply
Boosted
Print Profile
0.08mm layer, 2 walls, 15% infill
Top Modell
1
Reply
Boosted
Very nice design. Even when printing with a 0.2 mm layer, it turns out very well.
1
Reply
I suggest rotating the screws to print vertically for a smoother and rounder print. I also had to rescale the screws a little smaller for it to fit thru the hinges tightly.
The designer has replied
0
Reply
the screws are placed like this for a specific reason. print them vertical and they might snap at a layer. they have been tested, if they are not fitting I suggest to calibrate the filament you are using
(Edited)
0
Reply
This looks so good in wood filament.
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
very funny to assemble. will be a nice gift. (assembled or as a kit) thx 👍
1
Reply
Boosted
Print Profile
0.08mm layer, 2 walls, 15% infill
I love this design so badly, especially assembling part Got issues with lid not being fully closed due to some printing issues (on my side), but still - this is amazing design thank you!
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Turned out great! My kid loves it! I added magnets ro the inside of the latch to hold it closed better.
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
Nice treasure chest, printed one for my son and he really likes it.
1
Reply