I've recently ordered a 0.2mm Hot end assembly for my X1 Carbon and it was whilst swapping the hot ends over it I thought about this simple little accessory which makes the job so much easier.

Along with the accessories that came with the X1 and is probably the same on other Bambu Printer Models is an extended H2 Allen Key, these “L” shaped keys are the most awkward tools to use in a confined situation as this is, so I've designed this handle to eliminate that problem.

Once Printed you take the H2 Allen Key and cut the L end off with a dremel slicing blade or similar, file the cut edges smooth and then tap with a small hammer/mallet the handle onto the allen key cut end shaft, heat the allen key up before inserting if you are confident enough, I just tapped the handle onto the shaft and it works perfectly and saves quite a bit of time during the hot end swap out.

A simple but very useful addition to the printer accessory tool kit.

Thanks for Looking.