This is an alternative Beer Money Motorposts KAN Gauge V2 Oil Pressure location gauge pod. Here's the KAN Gauge V2:

https://www.beermoneymotorsports.com/products/kan-gauge

Note that this requires a friction fit between parts and most notably to the screen. Please be cautious about orientation when installing the screen.

I printed mine in PETG and suspect no issues in Florida summers. I do not recommend PLA for this and recommend at least PETG or ABS or higher temp materials (on preference). My 3mf assumes PETG to be used. The sparkle front comes from the textured build plate supplied with my P1S

Assembly Instructions:

Here are all parts printed next to the pieces they'll attach to:

First push the PCB into place with the wire connector facing toward the part of the print that was on the bed:

Next push the screen in screen side away from the part facing the bed:

Next, plug the screen into the PCB ensuring tabs are open to push ribbon in and that tabs are closed once inserted.

Then, push the assembled PCB part over the back of the assembled screen part:

Lastly, snap the front piece over the screen to clean up the assembled front: