This model requires assembly - and ideally glueing together (I use regular fast bonding glues - cyanoacrylate ones).

Colors are up to You - assembly is “dumb proof” - hopefuly :D

Start with Base → go on with tree_bottom → then snow_bottom → tree_middle → then snow_middle → tree_top → snow_top → end up with Star_top.

You can use also the “decorations” - i suggest to glue them before final assembly of whole tree. Otherwise it might be tricky to get them into place properly. Check the pictures - you can see small holes for decorations on bottom of tree parts.

I use this tree as a fence post cover during Christmas time. It fits my 60x60mm square tube posts. If there is a strong request, i can make the base for other types of “tubes” as well.

Print parts oriented as on the pictures and no supports are needed!

Enjoy!