This model is a fully printable shop towel pegboard mount with a quick load function for ease of use (and tactical towel reloads, of course). No dowel rods required! Fits a standard 1" x 1" pegboard, and can be removed/adjusted as needed.

Loading Mechanism In Action

--------------------------------------------------------------------------

V2 Updates

- Increased width of thumbscrew head for better handling

- reworked MountPartA so that the pegboard hooks sit more firmly into the board

--------------------------------------------------------------------------

Printing

The model is split into several pieces for strength/printability, and can be printed all at once or separately if you prefer to mix filament colors.

Supports will be needed for the MountPartA pegboard hooks, however the rest will print fine without any at all. The .3mf file PegboardTowelMount_allParts will also display preferred orientation for each piece.

This model works perfectly fine printed in PLA!

Assembly

1. Attach MountPartA to MountPartB via the dovetail joint. Refer to pictures to confirm orientation. Note: this piece is designed as a friction fit. Depending on your printer's tolerances, the pieces may need additional post processing.
   
2. Place the corresponding Hook over the mount, and secure with one Thumbscrew by screwing into MountPartB.
   
3. Repeat steps 1 - 2 for the other side, and you are done!

--------------------------------------------------------------------------

***All files have been uploaded to reflect recent changes, but V1 files will still be available if preferred