Do YOU have a 7.62x51 or a .308 rifle?! Are YOU tired of spending precious time at the range loading mags when you could be SHOOTING?!

Then I've got just the tool YOU NEED!!!

This tool here is designed in both the 13, AND NOW, the 10 round models!!! OH and Don't Forget, TOTALLY FREE!!!

The actual models do not have the text on them, it is purely for identification

The tool is designed for the magazine catch to catch the magazine catch hole on the standard magazine. The Mag Catch isn't required to make it work, but it certainly makes it easier when you're preparing for a long day of loading. You can use either standard gauge filament (1.75mm) or you can use a paperclip and superglue the ends (because I don't like doing something more than once, if I can help it). You can also add a spring (see last attached photo) to make the mag catch retention more reliable. I've put easily >500 rounds through my current working model and it has been perfect since I pulled it off of the print bed.

Although TOTALLY FREE, any help for these efforts would be greatly appreciated!!!

Simply:

1. Insert your SR-25/AR-10 magazine (be sure that the mag is caught by the mag catch)

2. Stack your rounds in the the feeding slot

3. Insert your Follower

4. Push the Follower until the ammunition is loaded into the magazine

5. Repeat steps 2-4 until magazine is full

6. Remove any non-loaded ammunition from the device (this will prevent any possible firearm malfunctions due to damaged ammunition)

7. Depress the magazine catch and remove the magazine from the loader

8. Repeat as needed

Please Enjoy My First Published Models!!!