Leaf soap dish

Full attribution to cecca_7 who won a contest for this beautiful model. https://www.printables.com/model/215518-leaf-soap-dish

It's a leaf soap dish in two parts. The design allows water to drain off and the inserted portion is elevated off the bottom by a tiny margin to prevent the insert from sticking. It fits a standard size bar of soap but this was intended for a nail brush, which fits well.

It's quite beautiful and intricate.

I've resized it to 80% of the original size, which was far too big, and reoriented the insert so that it will print properly - one side of the insert isn't flush and if you print it with this side down, the print will fail.

You can print it smaller, but not too much smaller - the leaf vein insert design is quite intricate and as it gets smaller, you may have problems with every line adhering to the bed.

Here it's printed in CC3D grass green PLA MAX for the base and FF SUNSENKJ translucent green PLA for the insert.