The Fat Fly - No Support Needed Remixed by MagnetDanny

Remixed by

MagnetDanny

Miniatures>Animals

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

No Support Fat Fly 0.2mm layer, 6 walls, 15% infill

Designer

15 min

1 plate

4.5(11)

Boost

Released

Description

What happens when a Fly overeats ? - It needs no support

Meet the Fat Fly, the chubby little critter that doesn't need any support to buzz around!

This remix of the original design:

https://makerworld.com/en/models/429296#profileId-333622

was created to print easily on the A1 mini printer without any extra support needed, only brim. Note that you need to make sure the fly look at you when you print it, rotating it in other directions it will need support, at least that's what happened to me on the A1 mini on all my trial and error.

With a plump belly, the Fat Fly is the perfect 3D printing project for those who love a touch of humor and a whole lot of creativity.

No more worries about printing small - the Fat Fly has got you covered! spread these all over the place and enjoy the reactions.

buzzingwithcreativity

Comment & Rating (20)

@JJTechPrints

Print Profile

No Support Fat Fly 0.2mm layer, 6 walls, 15% infill

What a masterful remix! I tried to print that original design with a 0.4mm nozzle and failed miserable. Tried all types of orientations. Lots of misprints. This print works great with 0.4mm nozzle. I can now print my army of flies! Thank you so much!

(Edited)

@YahooJAPAN

Boosted

obviously you can't print the original with a 0.4 nozzle because it was made for a 0.2 nozzle!

(Edited)

@LabLab

Boosted

don't worry! even with the 0.2mm nozzle the original one doesn't print great. I find this remix much better on this regard! specifically the lack of supports is an added value.

(Edited)