A1/A1 Mini - Nozzle Case - No hardware required
A1/A1 Mini - Nozzle Case - No hardware required
Print Profile(1)
Description
I created a case to store 3 nozzles for the A1 or A1 mini. It is printed with multicolor using the AMS, however it could be done without.
Everything snaps together. Be careful taking off supports to ensure you don't break anything but also remove all of the support material.
When snapping the hinge together for the top and bottom, make sure the lid is open at 90 degrees and then push it directly onto the hinge on the bottom. It might take some force but should snap in place. For the latch, point it down and push it onto the hinge. Slowly start to rotate it while still pushing down and you should feel it snap into place.
Good luck printing!
Comment & Rating (47)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
