Print Profile(1)
0.2mm layer, 3 walls, 20% infill petg
Designer
1.6 h
1 plate
Open in Bambu Studio
Boost
45
58
3
0
25
21
Released
Description
Hello everyone! This is my shoes cleaner tool for your car.
Are you tired about bringing dirt or gravel inside your beatiful and clean vehicle? With this you can easy remove anything stuck under your shoes. One side has a thin stick usefull to remove dirt or small rocks, the other has a brush for anything else (maybe a little bit tough)
Easy to print, I used PETG. If you got stringing, use a lighter and move it quickly to burn the strings.
Hope you all enjoy!
Meco
Comment & Rating (3)
All
Print Profile
0.2mm layer, 3 walls, 20% infill petg
It dulls out quickly and the brush end is too weak to clean shoes. maybe better with more wall+infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill petg
0
Reply
Print Profile
0.2mm layer, 3 walls, 20% infill petg
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld