Ender Raspberry Pi Side mount for Klipperscreen
Copyright Claim
Ender Raspberry Pi Side mount for Klipperscreen
Boost
0
0
1
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
46 min
1 plate
Open in Bambu Studio
Boost
0
0
1
1
0
0
Released
Description
Wanted a side mount for my old Ender 3 V2 Neo as I had converted it to klipper.
Will support a case 29mm x 65mm
The side screws are M3x16
The top screw is M3x6 ( I ran out of small screws so just popped a big one in for the photo)
The mounting nuts I used for the rails were some I had lying around from the below creator:
https://www.thingiverse.com/thing:3050607
This is the case I used as I had an adafruit screen. I'm sure others will fit.
Comment & Rating (1)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld