This is an X-Axis mount for Ender 3 & Ender 3 style printers. It goes directly before the nut, like a washer. This area is scooped and only 1mm thick in order to not interfere much. The plate design is versatile for any square / rectangle PCB style cameras. You can certainly make small pre-drill holes and screw your camera in if you would like. I use double sided tape. You can see the nozzle tip. In my timelapse example it may not be apparent because I have the nozzle tip quite close to the end of the silicone sock, and I am also using the MiniMe v4 hotend.
Printer Brand:
Creality
Printer:
Ender-3 v2
Rafts:
No
Supports:
No
Resolution:
0.12
Infill:
Gyroid @ 50%
Filament: Doesn't Matter, I used VOXEL PLA Pro
Notes:
You can print at lower resolutions and less infill, but the cost and time saving benefit is very minimal for the structure changes.
Category: 3D Printer Accessories