Shapeoko mountable edge clamp holder
Copyright Claim
Shapeoko mountable edge clamp holder
Boost
1
1
1
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
1
1
1
0
6
2
Released
Description
Shapeoko mountable holder for the edge and corner clamps. Can have any combination for a total of four.
If using the wood screw version, do not over tighten screws or you may split the printed part.
Not Affiliated with Carbide3D.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Fit is a bit tight but workable.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld