Tired of those cool car models just sitting in a box collecting dust and never being looked at? Well look no further, this simple wall platform can put your 1/18th and 1/24th scale car models on display for everyone to oooh and ah at!

The STL files provided do not have the car names on the file, however this is something that can be added once the file is downloaded.

***Note: The tire spacing should fit most cars, however some of the 1/18th and 1/24th scale models have different wheel spacing where some revisions might be needed to make your specific model fit.

Printed all in one print the the part that is again the wall sitting flat on the print bed. Printed at 0.15 layer height, 15% infill, and supports everywhere that prusa slicer saw fit.

***Use DuoPower #4-6 wall anchors in order to hold the platforms on the wall. Can put the screws into the anchors, leaving just enough room for the platform to go between the wall and the screw. Then the platform can simply be slid over the screw heads and pushed down to give it the “floating” appearance.***