This is one of the first 3d models I did after buying 3d printer about 2 years ago, therefore I apology for inconvenience and following allert.

!!!! Please check size before you start to print model as in my case I need to use 1000% instead of 100% size. !!!!

I printed this stand from PLA which still holds after 2-3 years.

Suggestion to buy:

1. Metal bearing 608 which is used for better spool movement, but you can print also part “spojnicova tycka” slightly bigger or use metal one instead
2. Eye bolt to help your filament to be guided - nut is not needed.

How to assemble:

Print all parts 1 times and click them inside prepared holes. You can use glue if you need better securing but parts should be tight enough (at least on my printer).

Eye screw is inserted into front connector