Replacement door pulls for your Bambu Lab printer. There are 5 versions available:

• Tall Pull
• Knob with Logo (Multicolor printer required)
• Knob without Logo
• Long Pull
• Crystal Pull - 2 pieces

Just remove the factory door pull and use the existing screws/washers to attach your new door pull. DO NOT OVERTIGHTEN!

Print Settings

Some pulls require their own special settings:

• Tall Pull
  • Move seam to back - this will allow you to hide the seam on the bottom once installed
• Knob with Logo
  • Move seam to back - this will allow you to hide the seam on the bottom once installed
• Knob without Logo
  • Move seam to back - this will allow you to hide the seam on the bottom once installed
• Long Pull
  • Supports are required - I prefer tree supports for this model
• Crystal Pull
  • Base
    • Supports are required for the first few layers only - supports CANNOT go into the screw holes
  • Crystal
    • Transparent filament looks best - 2 options
      • Option 1 - 100% infill
      • Option 2 - 0% infill
        • 3 walls
        • Use a 15mm cylindrical modifier with 10% infill in the center - full height of the crystal
        • 

Assembly Instructions

The two pieces of the Crystal Pull need to be screwed together.

Remove the factory door pull and use the existing screws/washers to attach your new door pull. DO NOT OVERTIGHTEN!

Buy Me A Coffee

The following filaments were used in the pictures above:

Tall Pull

• Bambu Lab Matte Scarlet Red PLA

Knob - No Logo

• Bambu Lab Basic Yellow PLA

Knob - Logo

• Bambu Lab Matte Ivory White PLA
• Bambu Lab Matte Grass Green PLA

Long Pull

• Bambu Lab Basic Cyan PLA

Crystal Pull

• Bambu Lab Silk Gold PLA
• Bambu Lab Transparent Teal PETG