I made this as a replacement for the stock mounting bracket that comes with this 4inch LED pod by Nilight.

This mount raises the light, and increases the range that the light can be tilted down and up.

Also included is a cap for the stock adjustment bolt that requires an allen wrench(hex key) to adjust. This cap is a snug fit and will require a bit of force to place on the bolt, but will allow you to hand tighten and adjust on the fly without the need for a tool.

The mount is designed to use a hex head bolt with head of 13mm (may actually read as 12.8 or somewhere in that range) with the bolt shaft diameter of 8mm (again, may read slightly less). It is 32.65mm from the top of the bolt to the bottom of the mount, so your bolt will need to be that plus the thickness of the material you're bolting it to plus room for a washer and nut. This is also made to be a snug fit and may require some force.

The print orientation is on its side, to provide maximum strength to the part. Supports are required, but i recommend using the support painting features, and removing supports for the bolt shaft hole. (leave the supports for the Hex head hole.

I printed in ASA for long term durability and UV resistance.

In the picture the mount is being used on a watercraft, but this can be used for automotive or outdoor recreational vehicles as well.

Link to the Lights- https://a.co/d/5HDJ2JW

Enjoy!