AMS Stacking by ultrajaxel for AMS RISER V2 Remix
Remixed by
Copyright Claim
AMS Stacking by ultrajaxel for AMS RISER V2 Remix
Remixed by
Boost
39
76
22
Print Profile(1)
0.2mm layer, 3 walls, 5% infill
Designer
16.2 h
2 plates
Open in Bambu Studio
Boost
39
76
22
6
82
38
Released
Description
This is an adaptation of the very great AMS Stacking System by Ultrajaxel for the TOP AMS Riser V2 by maCyo42
INFO
-complete bottom framework (rear and side bracers) for the AMS has been adapted
-the feet from AMS are on top for stability
-lower AMS lid opens and doesn't fall behind (stays standing alone)
-I print with the original print profile from Ultrajaxel only i use PLA (had problems with ABS “wrapping”)
-all remaining required parts and all information please use
https://makerworld.com/en/models/105669?from=search#profileId-112806
Ps.
I build things for my needs…. maybe someone can use it too!
sorry for my english!
Comment & Rating (22)
All
Re-labeled for easier viewing
The designer has replied
0
Reply
fits exactly as intended
0
Reply
the whole AMS should actually stand on its feet...so this has no influence
27 / 5.000
so this has no influence
27 / 5.000
so this has no influence
0
Reply
the base is not on the same horizontal plane, but is tilted. Does this affect the edge contact and support? Was the original design idea a continuous smooth transition? If it is a continuous plane, it should be more stable when placed on it.
The designer has replied
0
Reply
this makes no influence..everything fits perfectly an my riser! Photo 2 intentionally made (so that you can easily push it back and forth)..picture 3 you probably have a different ams version than me the distances are the same as with ultrajaxel
0
Reply
Is it only for V2?. I have V1 and does it fit too?
(Edited)The designer has replied
0
Reply
Unfortunately I don't know the differences V2 V1 or V3...I think mine is version 3 and could only test it with this version. Where can I see which version I have?
0
Reply
Had a hard time fitting the brackets into the slots under the AMS. The ends were a slightly off/too large and I had to sand them down a little bit. Any ideas what could have caused the issue?
The designer has replied
0
Reply
very curious...I printed it several times and also shortened it... Is it possible that there are several versions of AMS?
0
Reply
did you forgot to upload the middle green parts?
(Edited)The designer has replied
0
Reply
hi, the middle and all rest parts can use the original from ultrajaxel ;-)
0
Reply
Boosted
This will work on ps1?
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
The designer has replied
0
Reply
Thanks!!!! you have a picture?
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
The designer has replied
0
Reply
hanks!!! and works?
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
Support Issue
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
(Edited)
Other Issues:had some strings around the holes
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld