Parking Disc
Copyright Claim
Parking Disc
Boost
43
71
7
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
2 plates
Open in Bambu Studio
Boost
43
71
7
5
87
49
Released
Description
A parking disc to be used to display the time which you started parking. Three simple pieces snapped together to make the whole thing. Only to be used where a parking disc is applicable :)
I'm using 3 colors for this print on two plates, with a single color change for each plate. The color changes are not made by painting, but rather by switching filament in the preview. They are there even if not shown in the prepare stage!
The bottom part gets a little white on the top just because it is printed on the same plate as the top part (where the switch to white is necessary). It is not visible though as the white snaps into place on the inside, except for a thin, white stylish line around the disc :)
Dimensions: 11x11 cm.
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice. Printed on my A1-mini, so needed 3 plates. But that is simple enough.
Printed in PLA when I realised this will be in my carwindow. Maby PETG would be a better choise.
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
parfait 👌
0
Reply
Boosted
Well done! heading to Sweden to visit the in-laws and bringing a few. They will love them!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
ottima stampa
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld