Print in place - Marble fidget desk toy! by Binrux3D

Binrux3D

Toys & Games>Other Toys & Games

GIF

Print Profile(4)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

Marble fidget toy(full size)

Designer

2.7 h

1 plate

Marble fidget toy (50% size)

Designer

37 min

1 plate

3.5(2)

Marble ball(50% size)

Designer

8 min

1 plate

4.5(2)

Marble ball(full size)

Designer

15 min

1 plate

Open in Bambu Studio

Boost

Released

Description

Model:

Desk marble fidget toy! Featuring a fun mechanism to throw the ball towards the track! Have endless fun with this functional desk toy!

Printing:

Use provided print profiles for best results! I've tested sizes down to 25% which have still worked (check picture, but I'm only including the 100% and 50% versions as print profiles. If you want the 25% or 75% feel free to scale the print profile, or download the included STL:s.

!IMPORTANT! - If you download the STL:s remember to add supports for the ball launching mechanism, check photo below:

Also the ball needs to be cleaned after printing from all of the support residue. Use side cutters or a knife to get it round!

Not much else to it, enjoy!

Comment & Rating (10)

@cratica

Boosted

Print Profile

Marble ball(50% size)

Works Fine As Long As You Clean It Off Well I had to make sure it was perfectly round to get it to not get stuck. It took about 3 minutes.

The designer has replied

@Binrux3D

Thanks for the feedback! Yeah I will update the instructions, you are correct, the ball has to be cleaned.

@cratica

Boosted

Print Profile

Marble fidget toy (50% size)

(Edited)

Bed Adhesion Issue:Bed Adhesion Issue I saw this model on Makerworld and immediatly hit print. I was watching the print, and noticed that a small area, next to the cooling fan was sticking up. This could have easily been avoided with a higher bed tempature or lower cooling fan speed. (pictures below) It did not really affect the print. Overall the print is really cool as long as the ball is round. The bottom is a bit bendy and the launch mechanism is a little difficult to work.

The designer has replied

@Binrux3D

Thank you for the feedback! What material did you use? Did you have your cabinet open or closed? Could it be that it was too hot in there and it warped? I have printed about 5 of these (during testing and prototyping) and this hase never happenned to me. You can also DM me if you want, or we can keep the discussion here!

@cratica

Boosted

Nice work!

The designer has replied

@Binrux3D

Thanks!

@Panacaguy

Print Profile

Marble ball(50% size)

Smaller than I expected. I recommend duplicating to increase chances of getting at least one good one. It's cheap in terms of time and material, but is a good insurance policy. I printed three at once and only two survived.

The designer has replied

@Binrux3D

Thank you for the comment!