I was looking for a solution to mount some additional lighting inside the enclosure, but all the models I could find included a raiser. Instead, I wanted to keep the original aesthetic and mount the light inside the printer.
This rail is mounted on the left, front and right side of the printer and the light will point down at a 45 degree angle. It has all the necessary cutouts to sit nicely in the corner. The thin tape that comes with the light strip usually does not hold up to the repeated heat cycles and will eventually give out. The design of the rail will therefore make it possible to slide the light strip in from the side. It fits a light strip between 8-10 mm wide.
The rail needs to be mounted in the top of the enclosure, I recommended using good quality double sided tape like 3M VHB.
I printed this in PETG for extra heat resistance.
Hope you like it, please comment and rate. Happy printing!