Bobblehead for your Car or 3D Printer

It's quite a small box but prints fine on the 0.4mm Nozzle. 3 Filaments were used, black, green and white. But I have a single filament version attached for a quick print.

There is a tiny little bit of support on one end of the spring otherwise no supports needed on the Bobblehead cube. Designed in Fusion 360. The only thing I used was the idea for the spring which came from 3D Printy (Parametric Bobblehead Springs) but adapted for extra strength to use on this bobble head.

Stick some 3M tape at the bottom and mount on your 3D Printer or Car Dash. Parts press-fit together, no glue was used. You may need a small too if you have big fingers like me.

Enjoy.