I was missing a shower for the watering can and I thought everybody can buy it, so I sat down and designed this attachment for a 10 liter watering can. I designed it so that it is easy to print and has a large print area. I printed it in a 0.3 layer height and it is unfortunately not completely closed in the last layers but I guess with a little less layer height you can get a grip on it and it doesn't bother me because water should come out anyway ;-)
I also got the tip to put on a sealing tape for the heating to make the connection tight. Thanks for that!
Printer:
Geeetech A10
Rafts:
No
Supports:
No
Resolution:
0,2
Infill:
20%
Filament:
Geeetech PLAGold
Category: Outdoor & Garden