Sunlu FilaDryer S2 PTFE Adapter
Copyright Claim
Sunlu FilaDryer S2 PTFE Adapter
Boost
85
222
80
Print Profile(3)
0.2mm layer, 4 walls, 15% infill
28 min
1 plate
0.2mm layer, 3 walls, 25% infill
20 min
1 plate
0.16mm layer, 2 walls, 15% infill,
26 min
1 plate
Boost
85
222
80
0
432
341
Released
Description
With this PTFE adapter, you do not need to drill holes into your Sunlu FilaDryer S2 to attach it. The connector is attached with some double-sided tape. I used 3M VHB foam tape, it is strong but easy removable.
You need to remove the small tube part in one of the holes of the FilaDryer to have a better angle of the PTFE tube into the dryer, just push it out.
You need the following parts.
- 1x PC4-01 Bowden Connector
- A piece of heat-resistant double-sided foam tape (3M VHB is recommended).
Comment & Rating (80)
All
Print Profile
0.2mm layer, 4 walls, 15% infill
Not convinced this is the best orientation to print this in, but it did come out clean and works well enough. I mounted it with hot glue so that it would stay, but could be pulled off and cleaned up if needed. fitting also doesn’t screw all the way in, but it is in far enough.
0
Reply
What AMS riser is that?
0
Reply
Replying to @OCDTOOLFREAK
https://makerworld.com/models/133452
0
Reply
Replying to @OCDTOOLFREAK
the S2 holder is linked as a remix to the riser, so that is easy to find too!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill,
printed out perfect!
1
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
print went fine. it worked well even using TPU. :)
(Edited)
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Easy print, without supports, and fits greats to the Sunlu FilaDryer S2.
Thanks for this great design !
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
This works for me. Thanks!!!
(Edited)
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
just glued it with epoxy to the case, works!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill,
Great model easy print.
0
Reply
Print Profile
0.2mm layer, 3 walls, 25% infill
Looks good!
0
Reply
works fine thanks for the Model.
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Great work
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Share AlikeRemixes (1)
Related Models
© 2024 MakerWorld