AMS Dryer using chamber heat!

INFO: Been testing this, and getting not “enough” drying from this! 

With only the “active dryer” i get slightly above 60% humidity.

With Silica + “active dryer” I'm getting around 30-40% humidity. 

(Almost as same as only Silica, so i think this mod maybe its not that efficient)

I have a lot of problem caused by humidity here in Brazil, and was trying to figure a way to lower the humidty, without making a hole in the AMS.

The Humidity sensor is this really cheap one: https://s.click.aliexpress.com/e/_DkDYObn

*It's not mandatory, there's a file “AMS Riser Right With tube, Without Higrometer hole”.

The magnets are 4x 8x1,5mm: https://s.click.aliexpress.com/e/_DkxNP2h

The Hose i used has 24mm Inner diameter, I included the STEP file for mod if you want, or just send me a message with your common Hose diameter that i'll try to make this change!

I just installed and it started lowering the Humidity, I'll make a timelapse to show the real decrease in humidity!

I'm still testing it, the airflow from the chamber fan is really low, I still don't know if it will be enough to dry the 4 filaments in the AMS.