Update:

Since some new printers from BambuLab have a modified cable chain, the originally designed clip did not fit anymore.
There are two variants, please check which one you need, otherwise the clip will not fit.
The difference is in the height of the cable chain:
old version: height 14,4 mm --> print "old variant (14,4 x 9mm)".
current version: 15,0 mm --> print "new variant (15,0 x 9mm)".

This clip is the same as the original cable chain of the BambuLab X1 and P1P/S

My PFTE hose was too loosely routed on the cable chain for me, so I wanted more than one clip on the chain. The Clip is snap-fit just like the original and works fine for me.

Print it with ABS, PLA+ or PETG for durability.

The lower your layerheigh the more detailed clips you get.

Print Orientation: horizontally - flat on bed (i added a picture)

If you enjoy this, then please leave a like, comment or make here.