This is a portable mobile phone stand, the size is only 40mm×75mm×8mm, the length is smaller than the width of the phone, with seven-speed adjustment, there are two versions with and without the logo.

（这是一个的便携手机支架，尺寸仅为40mm×75mm×8mm，长度比手机宽度还小，带有七挡调节，有带标志和不带标志两种版本）
Print instructions:
Print 1.stl, 2.stl, 3.stl (without logo) three files;
Or print 1.stl, 2.stl, 3logo.stl (with logo) three files.

When carrying a phone holder, the pocket may be squeezed, and installation also requires toughness. It is recommended to use PETG printing.

（打印说明：
打印1.stl，2.stl，3.stl（不带logo）三个文件；
或者打印1.stl，2.stl，3logo.stl（带logo）三个文件。）

携带手机支架时口袋会挤压，安装也需要韧性，推荐使用PETG打印。
Assembly instructions:
1. Put the bottom side of 2.stl up, insert one protrusion into the small hole of 1.STL, and then push the other protrusion of 2.stl into the small hole of the other side of 1.STL.

（组装说明：
1.将2.stl底面朝上，一侧突出部插入1.stl的小孔，再将2.stl另一侧突出部推入1.stl另一侧的小孔。）

2. Insert the bottom of 3.stl (3logo.stl) with one side protrusion into the large hole of 1.stl, then press the other side protrusion of 3.stl (3logo.stl) with your finger, and push the other side protrusion of 3.stl (3logo.stl) into the large hole of the other side of 1.stl.

2.将3.stl（3logo.stl）底面朝上，一侧突出部插入1.stl的大孔，再用手指按压3.stl（3logo.stl）另一侧突出部，将3.stl（3logo.stl）另一侧突出部推入1.stl另一侧的大孔。

User guide:
1. Quick opening: Place the thumb at 2.stl, place the rest of the finger nails at the gap between 1.STL and 3.stl (3logo.stl), and press the thumb upward to quickly open.

使用指南：
1.快速打开：拇指放于2.stl处，其余手指指甲放于1.stl与3.stl（3logo.stl）的缝隙处，拇指向上按压即可快速打开。
2. After opening the 2.STL card to the 3.stl (3logo.stl) groove, you can have a seven-speed adjustable mobile phone stand.

2.打开后将2.stl卡到3.stl（3logo.stl）的凹槽，即可拥有一个七档调节的手机支架