This is a standalone adaptation of my CadetThrottle Module!
!!!IMPORTANT!!!
There are a few slight changes in this version compared to the module version. PLEASE follow these changes or your knob will not work!
CHANGES:
Straw length: 210mm
Straw hole distance (from the rear): 94.7mm
New potentiometer form factor:
----Travel: 100mm
----Mounting Hole Distance: 120mm
----Slide Shaft Width: 8mm
----Similar to these: https://www.amazon.com/IIVVERR-Potentiometer-Potenci%C3%B3metro-deslizante-Terminales/dp/B08LDV6FF4/ref=sr_1_4?dchild=1&keywords=100mm+slide+potentiometer&qid=1605547511&sr=8-4
You will also need to drill two additional M3 holes in your mounting surface to align with the 2 M3 holes on the front of the base.
Other than these changes, follow the rest of the build guide here:
https://youtu.be/W6DysglXp-0
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
15%
Black
Notes:
The sheath should be printed thread-side up using a brim to secure it firmly to the build plate.rnrnThe knob and push-button should be printed face down with support under the overhang circles.rnrnThe end cap is a rotary joint that prints in place. Use needle-nose pliers to break the joint free.