Update 05.06.24

Increased the gap between the threads. Now the screw is screwed in with little resistance. Just twist the screw back and forth a few times and it will rub in on its own.

==========

Personally, I had problems with the plastic coming off the textured plate and so I printed each part separately with raft.

Perhaps this is a problem with my plastic or insufficient adhesion area for the models, but keep in mind that there is a risk of printing failure without raft.

Also, after my printing, I slightly increased the thread gap, because I had to go through it with a tap. If the gap is not enough, let me know.