Ender 3/Pro, Fan Duct Voron style by Toxvaerd

Toxvaerd

3D Printer>3D Printer Accessories

Print Profile(3)

All

P1P

P1S

X1 Carbon

X1E

ASA 0.16mm layer, 3 walls, 25% infill

Designer

3.5 h

1 plate

ABS 0.16mm layer, 3 walls, 25% infill

Designer

3.4 h

1 plate

PEGT 0.16mm layer, 3 walls, 25% infill

Designer

3.5 h

1 plate

Open in Bambu Studio

Boost

Released

Description

v1 of my Fan duct for a good old ender 3. Please print in some higher temp materials such as PEGT ASA or ABS.

parts needed

5015 fan

6x m3 6-12mm screws

that's it.

install so easy it's dumb. remove old, slide the mounting plate down around the hotend, screw the originals screws in, place fans on the mounts, and ensure it all fits at the wires and is run nicely. then lastly screw the cover on and you're done. Happy printing!

DON'T USE SUPPORT!/only use touching the built plate or you will fill the part cooling air run thingys with supports that will block airflow.

Comment & Rating (4)

@uzuniita

DON'T USE SUPPORT!/only use touching the built plate ok now you can tell HOW orientate? there is a lot of things "print in air" as fell off , no print profile how can u?

The designer has replied

@Toxvaerd

i have made some print profiles

@uzuniita

Replying to @Toxvaerd :

i think u have to uncheck the "support only from build plate becouse i think cant print in air the 2 thing

@Toxvaerd

Replying to @uzuniita :

if you do that you end up blocking the part cooling. your printer can print those overhangs fine. its not a visibale feature so it doesnt matter too much.

No more