Anti vibration feet
Copyright Claim
Anti vibration feet
Boost
44
76
12
GIF
Print Profile(2)
0.16mm layer, 3 walls, 0% infill
Designer
1.9 h
1 plate
0.16mm layer, 3 walls, 0% infill
Designer
36 min
1 plate
Open in Bambu Studio
Boost
44
76
12
2
107
48
Released
Description
Anti vibration damper for Bambu Lab.
Very high damping effect.
he vibration measurements in the pictures are measured on the table where the Bambu is standing. 2.8 is the original value. 1.1 Comes with anti-vibration dampers.
Printed in TPU Shore 95
In the GIF you squeezed the printer with your hand to show what the spring action is like. In print mode there is not as much springing.
Comment & Rating (12)
All
Print Profile
0.16mm layer, 3 walls, 0% infill
its difficult to install them, but they work
(Edited)
The designer has replied
0
Reply
Hello
Thank you for your feedback. Can you tell me what exactly the problem is? The buffers go a little tight into the hole in the printer, but they hold better. Did you assemble them correctly? The depression you see in your photo is on the table...
0
Reply
Hola, como estas?
0
Reply
Print Profile
0.16mm layer, 3 walls, 0% infill
seem to make my printer worse compared to standard feet + cement block
The designer has replied
0
Reply
Good day, thank you very much for the feedback. How does the printer get worse? Have you done comparison tests? What kind of shore does your TPU have? Can you give me more information so that I can possibly make improvements. Thank you very much
0
Reply
Boosted
Print Profile
0.16mm layer, 3 walls, 0% infill
The designer has replied
0
Reply
Vielen Dank für die Bewertung und auch vielen Dank für den Boost-Token👍🏻😃
0
Reply
Boosted
die Dinger sind auch der Hammer ich danke dir
0
Reply
Print Profile
0.16mm layer, 3 walls, 0% infill
The designer has replied
0
Reply
thank you very much for the rating👍🏻😃 I would be very happy about a boost token😃 thank you
0
Reply
Print Profile
0.16mm layer, 3 walls, 0% infill
The designer has replied
0
Reply
thank you very much for the rating👍🏻😃 I would be very happy about a boost token😃 thank you
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld