Model pretty much speaks for itself doesn't it :-)

Got tired of all the different complex models out there, so decided to do my own.

Model doesn't need supports. 63Gram of filament.

Pull the spool from the stand ( reverse of what you did when putting it togehter ).

Remove the original clamps, slide on the centerring, orient the threaded pieces correct “there is notches to align”.

press in place, you'll hear a loud snap, ( all is good ) mount the spool and youre off to go.

Orange and green thread to counteract the rotation of the spool.

Green will air on its own model so people can choose.

Studs will be public also ( but with a thread that fits my models to come )

Kind Regards RESiX

Please don' share this outside Makerworld. Instead refer to the Original, as changes may come and will be here Only.

IMAGE is showing supports, as i have testet BOTH but they are not needed, you decide if you want supports.

print profile has supports disabled.

Added a Longer threaded Part in the RAW section : 
BOTH Orange and green extended thread parts from the RAW section have been printtestet without support and are Good to go.