After being tired of printer feet that require you to take half the machine apart to install, (at least that's what it felt like) I decided to design a snap-in version.
This was designed for my Voxelab aquila x2, but I have no doubt it will fit MOST other machines. This design does fit a little bit loose to avoid problems with it fitting.
It's also worth noting this requires you to push on the machine a little harder than most people would prefer. if you have problems with this, I will try to help.
Printer:
Voxelab Aquila x2
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
%100
Filament: SunLu PLA Orange