Flexi brush

Flexi brush

Boost
17
30
4

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

0.28mm layer, 3 walls, 15% infill
0.28mm layer, 3 walls, 15% infill
Designer
3.3 h
2 plates
5.0(1)

0.28mm layer, 3 walls, 15% infill, Optimized for the A1 mini
0.28mm layer, 3 walls, 15% infill, Optimized for the A1 mini
3.4 h
3 plates

Boost
17
30
4
0
14
5
Released

Description

English:
It is a flexible brush that is good for cleaning and brushing on glue.
Since it is made of TPU bristles, the glue can be easily removed after curing.
This brush is good for the environment because it can be used over and over again.
Fuzzy skin on the handle makes it easier to grip when brushing.

 

The bristles are marked A & B, 13 pieces of A and 13 pieces of B, total of 26.
Insert the retaining pin into the bottom of the frame (from the outside to the inside) so that it sticks out a little.
Now put the bristles A and B, A and B...
one after the other onto the pen and keep pushing them through until it is finally back in the frame.


Deutsch:
Diese Bürste bzw. dieser Pinsel eignet sich hervorragend zum Auftragen von Leim
und zur Reinigung im Inneren ihres Fahrzeuges.
Da sie aus TPU-Borsten besteht, lässt sich der Leim nach dem Aushärten leicht entfernen.
Dieser Pinsel ist gut für die Umwelt, da er immer wieder verwendet werden kann.
Fuzzy Skin am Griff sorgt dafür, dass er beim Bürsten griffiger wird.

Die Borsten sind mit A und B gekennzeichnet, 13 Stück A und 13 Stück B, also insgesamt 26.
Stecken Sie den Haltestift unten in den Rahmen (von außen nach innen), damit er ein kleines Stück herausschaut.
Jetzt stecken Sie nacheinander die Borsten A und B, A und B …
auf den Stift und schieben diesen immer weiter durch bis dieser am Ende wieder im Rahmen steckt.

Comment & Rating (4)

Please fill in your opinion
(0/5000)

love this model 🥰
The designer has replied
1
Reply
Thank you!
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
The designer has replied
0
Reply
Thank you for your rating !
0
Reply
No more