Ein Clip zur Befestigung des
"Raspberry Pi 3B+ Octoprint Case with Fan"
https://www.thingiverse.com/thing:4706774
Einfach an der gewünschten Stelle auf die Schiene klippen und das Case mit 2x M5x20mm Schrauben befestigen.
Passt auf den Ender 7, 5, 5S und andere Drucker mit identischen Schienen.
Füllung: 30%
Schichtdicke: 0.2
Keine Stützen (Supports)
Keine extra Druckbetthaftung (Rafts)
-----------------------------------------------------------------------------------------------------------------
Made a clip for the
"Raspberry Pi 3B+ Octoprint Case with Fan"
https://www.thingiverse.com/thing:4706774
Just snap it on and screw the Case with 2x M5x20mm screws at preferred side and height.
It will also fit Ender 7/5/5S and others with same rail size.
Infill: 30%
Resolution: 0.2
No Supports
No Rafts