A multi-functional footrest, use it anywhere, including the bathroom. The Bampūper can help you expel your human purges with peak efficiency by elevating your feet to a more ideal position. Watch as it shoots out of you just like the purges from your Bambu printer!

Printable on the A1 Mini!

--THIS IS NOT A STOOL, DO NOT STAND ON IT--

I designed it to use minimal filament while still being strong enough to support your feet. It WILL NOT support your full body weight though.

It is also not designed to easily come apart once assembled, so keep that in mind before you start. It's in multiple pieces purely for printing purposes.

The feet are optional, but can be printed in TPU to help reduce slipping.

~Assembly Tips~

Each piece will slide together a specific way, follow the animation below. I recommend looking over the sections that slide into place for any surface defects before assembling. Use a razor or filament cutters to trim off any excess “filament boogers” that you might have. This will make sliding the pieces together easier.

There are a total of 16 holes for the printable nuts and bolts. These make it MUCH stronger and more sturdy with less flexing, use them all for max strength. I recommend using PETG or stronger for these.

The printed nuts go on the side with the triangle cutout, the side with the circle hole is for the bolts. The triangles will prevent the nut from spinning when tightening the bolts. Hand tightened should be more than fine, but I did add some notches so that a coin or screwdriver could be used. Their main purpose is to prevent separation of the pieces and not actually for shear strength.

Licenses:

Selling physical prints of my files with attribution is OK

Re-uploading or selling my digital files is not