Gladiator Storage Bin
Copyright Claim
Gladiator Storage Bin
Boost
2
11
6
Print Profile(1)
0.2mm layer, 4 walls, 25% infill
Designer
15.5 h
2 plates
Open in Bambu Studio
Boost
2
11
6
0
12
8
Released
Description
This Storage bin will work with the Gladiator Slatwall system and any other slatwall system that their hooks will work on.
There are 2 versions, one with hex holes on each side or one that is completely solid.
The bin measures 195mm wide, 103.90mm tall, and 159.43mm deep.
Print Settings:
Layer Height: 0.20mm
Infill: 25%
Walls: 4
Supports Required: Yes
Other: Used tree supports for the rear hook.
Comment & Rating (6)
All
Might want to print this on its side for best strength properties
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
The designer has replied
0
Reply
Was there something wrong with the print or print file? I'd like to correct it if possible
0
Reply
Replying to @Redevil1111
To be honest not quite sure. Mostly cosmetic Issue where walls interface the base, and also upper hex grid. Printed with polylite Pro with ps1 standard mode. I also shortened width of box in slicer. Overall the interface with gladiator system is solid and the box is sturdy. Your model is good and I will print more in the future. might chalk up to my slicer mods and settings. Thanks for sharing.
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 25% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld