Holds your GRR-RIPPER block vertically on your wall or french cleat.

All other designs of GRR-RIPPER holders tend to require the holder horizontally (to use the rails), or just uses a flat surface to rest it on. I find the notch inside sufficient for vertical hold. Not enough holding power if you are mounting this on a high-vibration surface (eg, your saw chassis), but definitely enough if it's a real wall.

Print Instructions:

• 3 perimeters
• PETG
• Gyroid 15% infill
• main body vertical
• hanger T requires support (tree works fine)

Assembly:

• dry-fit first
• CA glue the two pieces together
• seam should be flush