Bambu Spool easy stater core
Copyright Claim
Bambu Spool easy stater core
Boost
172
381
151
Print Profile(5)
Original
Designer
2.7 h
1 plate
0.2mm layer, 2 walls, 8% infill
53 min
1 plate
Diameter+0.2mm,height -0.5mm,0.2mm layer,2 walls, 15% infill
1.5 h
1 plate
Scaled up for easy fit 0.2mm layer, 2 walls, 8% infill
1.1 h
1 plate
Click to see more
Open in Bambu Studio
Boost
172
381
151
12
595
515
Released
Description
This Core is to be used with a Bambu spool to make it easy to get a clean perfect start every time you are using a re spooling winder. It holds tight until the spool is low and then it lets go just fine so there is not a hang up or a clog at the end of a roll.
How to use:
Just put the core on your spool, lock the spool shut then shove filament tip in the hole and re-spool turning in the direction of the arrow on the Core
Comment & Rating (151)
All
What a brilliant design.
Just recently built a V-Spooler and this piece was just what I had been missing :-)
Sorry, can't rate right now because I accidentally deleted my print history...
Will try when I print the next batch
(Edited)
The designer has replied
1
Reply
Awesome, glad you like it. thanks for the comments
0
Reply
Boosted
Print Profile
Original
great model, perfect fit
The designer has replied
0
Reply
Awesome, thanks for the rating 😁
0
Reply
Print Profile
Original
Works great!
The designer has replied
0
Reply
Thanks for the rating 😁 looks great
0
Reply
Print Profile
Original
This print is perfect! Works as advertised; very well done. 👍🏾
The designer has replied
0
Reply
thanks for the rating 😁 Glad you like it
0
Reply
Print Profile
Original
Haven’t used it as a starter yet. But they print great.
The designer has replied
0
Reply
thanks for the rating, glad you like them 🙂
0
Reply
Print Profile
Original
printed fine
The designer has replied
0
Reply
Great, glad you like it. thanks for the rating
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
very useful
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
Respooling is so much easier with these.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill
a bit tight but this is because of self printed spools
0
Reply
Print Profile
Original
The designer has replied
0
Reply
thanks for the rating
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld