Bambu Spool easy stater core
Copyright Claim
Bambu Spool easy stater core
Boost
136
302
131
Print Profile(5)
Original
Designer
2.7 h
1 plate
0.2mm layer, 2 walls, 8% infill
53 min
1 plate
Scaled up for easy fit 0.2mm layer, 2 walls, 8% infill
1.1 h
1 plate
0.2mm layer, 2 walls, 15% infill
1.5 h
1 plate
Click to see more
Boost
136
302
131
2
501
436
Released
Description
This Core is to be used with a Bambu spool to make it easy to get a clean perfect start every time you are using a re spooling winder. It holds tight until the spool is low and then it lets go just fine so there is not a hang up or a clog at the end of a roll.
How to use:
Just put the core on your spool, lock the spool shut then shove filament tip in the hole and re-spool turning in the direction of the arrow on the Core
Comment & Rating (131)
All
What a brilliant design.
Just recently built a V-Spooler and this piece was just what I had been missing :-)
Sorry, can't rate right now because I accidentally deleted my print history...
Will try when I print the next batch
(Edited)
The designer has replied
1
Reply
Awesome, glad you like it. thanks for the comments
0
Reply
Print Profile
Original
Works great!
The designer has replied
0
Reply
Thanks for the rating 😁 looks great
0
Reply
Print Profile
Original
This print is perfect! Works as advertised; very well done. 👍🏾
The designer has replied
0
Reply
thanks for the rating 😁 Glad you like it
0
Reply
Print Profile
Original
Haven’t used it as a starter yet. But they print great.
The designer has replied
0
Reply
thanks for the rating, glad you like them 🙂
0
Reply
Print Profile
Original
printed fine
The designer has replied
0
Reply
Great, glad you like it. thanks for the rating
0
Reply
Print Profile
Original
The designer has replied
0
Reply
looks great! Glad you like it 😄
0
Reply
Print Profile
Original
printed great, but doesn't work with my spools.
The designer has replied
0
Reply
it only fits Bambu refill spools. And I recommend printing in PLA. thanks for the rating
0
Reply
Replying to @TKB3D
Thank you so much. I did print with PLA, but was not trying ur model with Bambu refills. But, I will!
0
Reply
Print Profile
Original
Very nice design and fits perfect.
The designer has replied
1
Reply
thanks! Glad you like it
0
Reply
Didn't fit my Bambu refill spool - just a tad small. Tried forcing it on and almost got stuck. Printed on A1 Mini with designer profile. May try reprinting on P1S or scaling to 101%
The designer has replied
0
Reply
I know people had trouble that did not use PLA or was using the printed bambu spool not the one that comes with Bambu filament.
0
Reply
Print Profile
Original
quick and easy print
The designer has replied
0
Reply
thanks for the rating
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld