Panda Touch USB Cover for P1S
Copyright Claim
Panda Touch USB Cover for P1S
Boost
9
20
7
Print Profile(2)
0.2mm layer, 2 walls, 10% infill
Designer
42 min
1 plate
0.2mm layer, 2 walls, 10% infill
51 min
1 plate
Open in Bambu Studio
Boost
9
20
7
0
33
31
Released
Description
This is my first published model outside of designing and making things for myself.
I made this USB cover for the BTT Panda Touch after printing a few of them and they did not fit due to the riser I have. So I designed this USB cover. It may fit the X1C and the P1P. The cover fits in the the open hole in the top plate and then uses double sided tape to attach to the printer. I added a slight recess to give the model a better look than just being a block.
I printed in PETG with Bambu PETG setting and with supports.
Comment & Rating (7)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
Printed fine. only complaint is that I wish the cable fit a little tighter in the cable grove. If lifted, the cable slides right out and can be frustrating to slide back in as it doesn't fit tightly.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
very nice
The designer has replied
0
Reply
Thank you! I appreciate the positivity
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld