Calibration Poopline Bin- no Label-P1P P1S Upgrade by RealNationPrint

RealNationPrint

3D Printer>3D Printer Parts

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.16mm layer, 2 walls, 15% infill

Designer

1.5 h

1 plate

4.8(13)

0.2mm layer, 2 walls, 15% infill

Designer

1.3 h

1 plate

4.8(8)

Open in Bambu Studio

Boost

118

126

Released

Description

Calibration Poopline Bin V1

Upgrade your BambuLab!
Collect your Pooplines and Trash of the Buildroom in your perfect sized Bin.

Calibration & Stripremover:
https://makerworld.com/en/models/411446#profileId-313358

For my other designs visit:

https://makerworld.com/en/@RealNationPrint

I'd appreciate a like/follow/comment/Printrate and further support! Thank you
Wanna buy me a coffee for my good work? https://www.paypal.me/Realmascha

Comment & Rating (26)

@analyticOne

Print Profile

0.16mm layer, 2 walls, 15% infill

fits perfect thanks so much

@3print360

Print Profile

0.16mm layer, 2 walls, 15% infill

works great

(Edited)

@Haraise_Tenshi

Why is the model split into 4 objects and default set to print without supports?

The designer has replied

@RealNationPrint

Normaly Supports Must be on / i will Check it later. thanks for the Feedback.

@RealNationPrint

Fixed it!

@morphf

Print Profile

0.16mm layer, 2 walls, 15% infill

It’s a good model. Printed perfect. but if 1 may a suggestion for v2, the model is hanging/floating. Make it a little deeper so it’s resting on the bottom.

The designer has replied

@RealNationPrint

Thanks for your Feedback Done. Height was changed by 4mm so it stand save and closely on the Ground now. :) And added a small "lip" on the other side which can help remove little particle from the Buildrooms ground.

(Edited)

@Vaperland_2.0

Print Profile

0.2mm layer, 2 walls, 15% infill

fit perfectly

@Goodwill

Print Profile

0.16mm layer, 2 walls, 15% infill

love it

@christian9119

Print Profile

0.2mm layer, 2 walls, 15% infill

almost great, but there's a lot of blobs over the whole model.

@Milosyu

Print Profile

0.16mm layer, 2 walls, 15% infill

Perfekt

@shrimpisbugss

Print Profile

0.2mm layer, 2 walls, 15% infill

This thing is great haha. Now I can collect all my poop lines instead of just balling them up and throwing them in the PLA recycling box.

@SevenxMinutes

Print Profile

0.16mm layer, 2 walls, 15% infill

Great fit, easy print, support came right off. The box can get static-y inside the print volume, so sometimes the lines can stick out a little. I suspect this is a filament specific thing, but something to be aware of if using.