Momentum Fidget Spinner
Copyright Claim
Momentum Fidget Spinner
Boost
32
58
5
Print Profile(1)
0.2mm layer, 2 walls, 25% infill
Designer
31 min
1 plate
Boost
32
58
5
2
49
25
Released
Description
Post-Printing
Uses 10mm diameter rare earth magnets, which come in a variety of thicknesses - The thinner magnets allow for more configuration options, using more magnets should result in transitioning at higher speeds.
Superlube oil* or similar - I usually disassemble it after printing and a few minutes of break-in, then add one drop of superlube into each of the pivot points.
Comment & Rating (5)
All
I haven't used superlube on the joints yet, but how is the magnet configuration? I assume they should be opposites, so they push away from each other?
It spins for me, but only 7 or 8 times... nothing crazy. Does the lube make that much difference, or am I doing something wrong?
0
Reply
Print Profile
0.2mm layer, 2 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 25% infill
(Edited)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld